грувбокс вроде настроен
я все по мануалу External Sequencing with the MC-505 делал:
1е.
Using the MC-505 as a Slave to a Sequencer
Use the following procedure to set up the MC-505 to follow
the MIDI clock of a sequencer. In this type of setup
the sequencer will be used to start and stop the MC-505:
1) Connect a MIDI cable from the MIDI OUT of the
sequencer to the MIDI IN of the MC-505.
2) While holding SHIFT, press KEY PAD 11 (fig. 1).
3) Use the VALUE dial to select Sync Mode =
SLAVE, then press EXIT.
2е.
1) Press PTN/SONG so it is lit and use the VALUE dial
to select U:001 EMPTY PATTERN. If U:001 is not
empty, use the VALUE dial to select a user pattern
that is empty.
3е.
1) While holding SHIFT press KEY PAD 12.
2) Use the VALUE dial to select Remote Kbd = OFF.
3) Use the PAGE </> buttons to select MIDI Rx SW.
4) Use the PART SELECT buttons and the VALUE dial
to set these all to + (On).
5) Press EXIT.
4е
Copying Data from a Sequencer to the MC-505
1) Connect a MIDI cable from the MIDI OUT of the
sequencer to the MIDI IN of the MC-505.
2) Set the MC-505 to slave to MIDI clock (see section I:
Using the MC-505 as a Slave to a Sequencer).
3) Select an empty User Pattern and press RECORD on
the MC-505.
4) Use the PAGE </> buttons and the VALUE dial to
set the Beat (usually 4/4), Pattern Length, Count in
(try 0), Loop Rest, and Input Quantize.
5) Start the external sequencer and the data will automatically
be recorded into the corresponding parts of
the MC-505 (as shown in figure 2 on page 3).
6) Stop the sequencer when the pattern is finished.
то есть что касается грувбокса я все настройки вроде сделал
он прекрасно все играет у меня из куба
партии идут по миди каналам
все чин чинарем
но вот когда я хочу записать патерн
а потом проиграть его уже в грувбоксе, без куба, то ничего не получается
записывается какой то набор звуков
leasantry: