Майк Мартин (TC Electronic) :
The driver was posted today for Windows XP. The direct link is here.
http://www.tcelectronic.com/default.asp?id=10709
couple of notes regarding the new version -
Assimilator Konnekt is part of the installation. If you have Assimilator Konnekt installed, please uninstall it before this installation.
The software package includes a firmware update - the firmware update tool is found on the about page.
As Craig stated in his version, you may get an error message when either updating the firmware or using the Reset function, please don't be concerned about this its a known issue but they were focused on other areas rather than this.
This version is NOT "signed". The primary delay we've been facing since Craig received a beta a couple weeks ago is that we've been working with Microsoft to get the proper certificate. This takes three business days between each revision. They've been going round and round to get it corrected and I'm told it will be fixed by next week. So with this version, you'll get 5 warnings that this driver is not signed (Konnekt itself, MIDI IN, MIDI OUT, WDM drivers, ASIO Drivers)
This driver is six revisions newer than the one that Craig has. There have been numerous improvements.
My recommendation -
Power off or disconnect your Konnekt. Run the existing uninstaller. It should prompt you to reboot if you were using 1.10.
Install the new version. Once complete, reattach Konnekt.
One last note. Though I'm sure people will comment about the new software here. We need your feedback directly. Please send all feedback, positive and negative to konnektbeta@tcelectronic.com along with your system specs.
=====================
какие будут отзывы?
The driver was posted today for Windows XP. The direct link is here.
http://www.tcelectronic.com/default.asp?id=10709
couple of notes regarding the new version -
Assimilator Konnekt is part of the installation. If you have Assimilator Konnekt installed, please uninstall it before this installation.
The software package includes a firmware update - the firmware update tool is found on the about page.
As Craig stated in his version, you may get an error message when either updating the firmware or using the Reset function, please don't be concerned about this its a known issue but they were focused on other areas rather than this.
This version is NOT "signed". The primary delay we've been facing since Craig received a beta a couple weeks ago is that we've been working with Microsoft to get the proper certificate. This takes three business days between each revision. They've been going round and round to get it corrected and I'm told it will be fixed by next week. So with this version, you'll get 5 warnings that this driver is not signed (Konnekt itself, MIDI IN, MIDI OUT, WDM drivers, ASIO Drivers)
This driver is six revisions newer than the one that Craig has. There have been numerous improvements.
My recommendation -
Power off or disconnect your Konnekt. Run the existing uninstaller. It should prompt you to reboot if you were using 1.10.
Install the new version. Once complete, reattach Konnekt.
One last note. Though I'm sure people will comment about the new software here. We need your feedback directly. Please send all feedback, positive and negative to konnektbeta@tcelectronic.com along with your system specs.
=====================
какие будут отзывы?
